Horde3D

Morning, ive just come across a new problem in converting some content over to Horde, ive just swapped to a new Collada exporter which until now appears to have been working fine - however ive just tried exporting a sphere, and for some bizarre reason the geo converter has lopped off a part of it leaving only a few faces (attached a screenshot).

From what I can tell theirs nothing wrong with the Collada file, and works fine on other shaped objects.. at a loss to explain.

_________________

Let's bring 'em out! Any old iron! Any old iron!
A door opens and a homewife brings out a rather sophisticated-looking ground-to-air missile system, and dumps it on the cart.
Thank you.

Could you provide the collada file?

Very strange, I thought I would create a couple of spheres to test scaling and to send one over, though it appears to be working once again I will leave it for now, and see what happens as ive not changed the workflow.

Best Regards,

_________________

Let's bring 'em out! Any old iron! Any old iron!
A door opens and a homewife brings out a rather sophisticated-looking ground-to-air missile system, and dumps it on the cart.
Thank you.